46

ゴムボール衝撃源による重量床衝撃音について

タイヤ衝撃源との比較と床仕上げ材による影響

田中 ひかり*1・田端 淳*1

重量床衝撃音の測定で現在主に使用されている衝撃源はタイヤ(衝撃力特性(1))であるが、最近では衝撃源としてゴムボール(衝撃力特性(2))を積極的に用いていこうとする動きが見られ、評価には最大A 特性床衝撃音レベルを用いることが議論されている。
そこで、測定法の移行に先立ち、ゴムボール衝撃源を用いた測定値が従来用いられてきたタイヤ衝撃源の床衝撃音レベル等級とどのような関係にあるかを調べた。
また、従来のタイヤ衝撃源による測定ではコンクリート素面床の状態に対し、乾式二重床で仕上げることによって衝撃音が増幅される傾向があるため、ゴムボールの場合の床仕上げによる影響を調べた。

キーワード:  床衝撃音遮断性能,衝撃力特性(2),最大A特性床衝撃音レベル

*1 技術センター 建築技術研究所 環境研究室

Investigating the Impact Sound Insulation of Building Floors with a Rubber Ball

Comparison of Tire and Rubber Ball as Impact Sources, and the Influence of Floor Coverings

Hikari TANAKA*1 and Atsushi TABATA*1

The insulation characteristics of a floor are conventionally evaluated by heavily impacting the floor with a small automobile tire. A rubber ball has been included in the Japan Industrial Standards (JIS) since 2000 as a heavy/soft impact source. Rubber balls are expected to become widely used along with conventional tire sources.
According to the JIS, floor impact sound pressure levels are measured per octave and evaluated by a comparison with rating curves. However, the A-weighted impact sound pressure level is used for rating a floor’s impact sound insulation performance.
In this study, the floor impact sounds of a tire and a rubber ball were compared. The influence of a floor covering on the impact sound of a rubber ball was also investigated.

Keywords:  floor impact sound-reduction performance, impact force characteristics (2), A-weighted impact sound pressure level

*1 Environmental Engineering Research Section, Building Engineering Research Institute, Technology Center