高性能低周波吸音材の開発
増田 潔*1・関 雅英*2・岸 保之*2
従来の吸音性能の高い多孔質吸音材で,63〜125Hz帯域の低周波音に対し高い吸音性能を得ようとすると,その厚さは500mm以上にもなる。そのため,低周波音用の吸音ユニットや低周波音用の空調設備のサイレンサーはどうしても大きなものになってしまう。そこで,半分以下の厚さで63Hz〜125Hzの低周波音に対して同等の性能を得られるような高性能低周波吸音材を開発した。開発した吸音材は,密度の高い多孔質吸音材に特殊皮膜を接着した特殊皮膜付吸音材を基本材料とし,その背後に密度の低い多孔質吸音材を配置したものである。独自に開発した設計式を用いることで任意の周波数で高い吸音率を得られるように設計できる。特殊皮膜付吸音材背後だけではなく,前面にも多孔質吸音材を配置することで,低周波音から高周波音まで幅広い帯域で高い吸音率を得ることも可能である。
キーワード: | 低周波音,膜吸音材,吸音率,設計関数 |
*1 技術センター 建築技術研究所 環境研究室
*2 昭和電線デバイステクノロジー(株)
Development of High Performance Low-frequency Sound Absorber
Kiyoshi MASUDA*1, Masahide SEKI*2 and Yasuyuki KISHI*2
Porous materials must be more than 500mm thick to absorb low-frequency sounds in the 63 to 125 Hz octave band. Therefore, low-frequency sound absorbers for room acoustics and silencers for air conditioners are large. We have developed a high performance low-frequency sound absorber that is less than half the thickness of standard sound absorbers. This absorber consists of a thin soft membrane glued to a high-density porous board, and layered porous absorbing materials. The peak absorbing frequency can be designed using a theoretically derived calculation function. A high performance, wide-band low-frequency sound absorber can be produced by placing layered porous absorbing materials in front of the special membrane absorber.
Keywords: | low-frequency sound, membrane absorber, sound absorption coefficient, design function |
*1 Environmental Engineering Research Section, Building Engineering Research Institute, Technology Center
*2 Showa Device Technology
48 - REPORT OF TAISEI TECHNOLOGY CENTER No.44 2011