37

帯状の鋼材で補強されたT型RCはりの正負交番載荷実験と数値解析

村田 裕志*1・福浦 尚之*1

地中の土木構造物には,RCの壁付き柱部材が多くある。これらの部材を耐震補強する場合,連続した壁があることから,通常の柱の耐震補強で行われるような鋼板巻立て工法や繊維シート巻立て工法は適用できず,また,壁背面側(地盤側)からの施工が事実上不可能である。そこで,柱部から壁部に連続する帯状の鋼材(鋼帯)を設置してこれを接着系アンカーで固定する方法を提案した。この簡易な補強方法の効果を確かめるため,RC壁付き柱部材を水平にしたせん断補強鉄筋のないT型RCはりで正負交番載荷試験を行った。さらに非線形有限要素解析により側方鉄筋やフランジ(壁部)がはりのせん断挙動に与える影響を明らかにした。

キーワード:  RC壁付き柱,T型RCはり,耐震補強,正負交番載荷実験,非線形有限要素解析

*1 技術センター 土木技術研究所 土木構工法研究室

Cyclic Loading Tests and Numerical Analyses of T-shaped RC Beams Reinforced with Steel Belts

Hiroshi MURATA *1 and Naoyuki FUKUURA *1

Many underground civil engineering structures contain RC columns that are contiguous with the side walls. When seismic retrofitting of these members is required, the steel plate and FRP jacketing methods commonly used to retrofit RC columns are not applicable. Any retrofit method that requires access from behind is impossible because of the continuous wall. The authors suggest a simple new method of seismic retrofitting in which steel belts are attached to RC columns using a chemical anchor. In order to confirm the performance of this method, cyclic loading tests on T-shaped RC beams without stirrups were performed. Moreover, nonlinear finite element analysis was carried out and the effect of the flange (the side wall) and lateral longitudinal reinforcement on the shear capacity of the beam was clarified.

Keywords:  RC column with side wall, T-shaped RC beam, seismic retrofitting, cyclic loading test, nonlinear finite element analysis

*1 Civil Structure and Material Research Section, Civil Engineering Research Institute, Technology Center