20

高強度コンクリートの打込み上面に生じるこわばりの測定方法

山本 佳城*1・陣内 浩*1・飯島 眞人*2・寺内 利恵子*2・渡邉 悟士*1・黒岩 秀介*1・並木 哲*1

水結合材比が20%程度を下回るような高強度コンクリートでは,打込み上面にこわばりが早期に発生する場合があるため,これに配慮した適正な養生計画が必要とされている。しかしながら,上記のようなこわばりを取り扱った検討例はまだ少なく,こわばりの固さや厚みなどの状況,その測定方法などが必ずしも明らかではない。そこで本研究では,Fc150N/mm2程度の高強度コンクリートを対象として,貫入抵抗を利用したこわばりの測定方法についての基礎検討を行った。
本研究の成果として,打込み上面に生じるこわばりの有無や固さ,おおよその厚み,打込み上面の乾燥程度の相違によるこわばり状況の変化などを捉えることのできるこわばり測定方法を考案した。本測定方法は,各種養生剤やその他のこわばり抑制手法の効果を評価するうえで有用となることが期待される。

キーワード:  高強度コンクリート,こわばり,貫入抵抗,含水率,養生剤

*1 技術センター 建築技術研究所 建築構工法研究室
*2 建築本部 技術部 建築技術部

Method of Measuring Premature Stiffening Zone Formed at Top of High-Strength Concrete after Placing

Keiki YAMAMOTO *1, Hiroshi JINNAI *1, Masato IIJIMA *2, Rieko TERAUCHI *2, Satoshi WATANABE *1, Shusuke KUROIWA *1 and Satoru NAMIKI *1

This paper discusses a method of measuring the premature stiffening zone formed at the top surface after placing high-strength mortar with a water-binder ratio below 0.2. First, through experiments, a method of measuring the premature stiffening zone is devised based on penetration resistance measurements. The penetration resistance distribution, resistivity distribution, and moisture content of mortar specimens simulating high-strength concrete with a design strength of approximately 150N/mm2 are then measured to assess the appropriateness of the measurement method.
The results reveal that the measuring method devised is suitable for determining the occurrence and approximate depth of the premature stiffening zone in the case of high-strength mortar.

Keywords:  high-strength concrete, premature stiffening zone, penetration resistance, moisture condition, membrane curing

*1 Building System and Material Research Section, Building Engineering Research Institute, Technology Center
*2 Technology Promotion Department, Building Construction Division